9/27/2023 0 Comments Makeshift incubator for eggsIf the temp and or humidity need to go up you can start sealing off some of the cracks with duct tape. Give it a couple of hours so you can be sure. ![]() Now, Put the cover on it and monitor the temperature and humidity. In this picture now you can see how I have taped the bulb socket in place. Now put your sponge and waterbowl in and fill it half way with water and place your thermometer. The screen is optional though, you could build your incubator without it. This is why you tape it firmly in place and put this screen around it. It could cause undue heat or possibly a fire. You don't want your bulb contacting anything. The screen forms just a safety enclosure for the bulb on the right. This will keep the chicks clean as they leave droppings. This part is up off the bottom of the cooler by about an inch. The flat part on the left is where the eggs,water and thermometer go. But for now let's also bend and place our screen. (You should firmly tape this in place with duct tape both on the inside and outside. Cut a hole in one end of the cooler and insert the socket for your bulb then screw on the bulb. Now let's install the bulb then the screen. You now have an observation window you can look down into the incubator through. Tape the glass down to the cover with duct tape. You don't want the glass to fall through. It should be at least an inch smaller on all sides. Use this as a guide and cut a square hole out of the cover that is almost as large as the glass. Take the glass or plastic out of your picture frame and put it right on top of the cover of the cooler. The first thing to do is make the observation window. That setup will simply plug right into the wall. Often times you can take apart a lamp like this to get the socket and wire out. The type with 1/4 inch squares is perfect (optional)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |